Rubber Hose Maintain the use of
Maintain the use of editing
Maintenance of rubber tube after installation
Proper use of rubber tube
It is important to determine the length of the rubber tube you need, and you should also check that the conditions of use of the hose meet the requirements of the selected hose. Make sure you will use the rubber tube is the most appropriate. Care should be taken to determine the working pressure and the suction value. In particular, it should be noted that sudden pressure changes or pressure peaks exceeding the permissible maximum will significantly shorten the life of the rubber tube. The ends of the rubber tube can not be continuously immersed in the conveyed material.
2. Install the rubber hose for use
If you install the rubber tube so that the bending radius is less than the specified minimum value, the life of the rubber tube will be greatly reduced. Therefore, before the installation, it is recommended that you use the information to consult, especially the rubber tube bending radius of the information.
3. Rubber tube maintenance
Cleaning: After using, it is recommended that you clear the hose. If necessary, should be cleaned. Check: After each use must check the rubber tube to ensure that it does not appear structural damage. Pressure: Hydraulic tests are recommended if the rubber tube is subjected to severe pressure during use or if the outer layer of the rubber tube is in contact with the delivered liquid for a long time.
Rubber tube storage recommendations
Due to the natural nature of the rubber, the physical properties and performance levels of all rubber products will change. Such changes are usually made over time depending on the type of rubber used. But may also be due to several factors or a combination of several factors to accelerate the change. Other materials used to reinforce the rubber tube may also be adversely affected by improper storage conditions. The following recommendations contain a series of precautions to maximize the prevention of aging of the object in storage.
1. storage time
A rotation plan system should be used to minimize the storage time of the rubber tube as much as possible. If you can not avoid prolonged storage and can not comply with the following recommendations, you should thoroughly check the rubber tube before use.
2. Physical storage conditions
The storage of the rubber tube must avoid mechanical stress, including transition stretching, pressing or deformation, to avoid contact with sharp or sharp objects. The rubber tube is preferentially stored on a suitable stand or placed on a dry ground. The rubber tube of the coil pack must be stored horizontally and the rubber tube should not be stacked. If stacking is not avoided, the height of the stack should not cause permanent deformation of the rubber tube underneath. As one of the regulations, try to avoid the rubber tube around the column or the hook. If the rubber tube is shipped in straight pipe, it is recommended to store it horizontally without bending it.
3. Contact with other materials
Rubber tubing shall not be exposed to solvents, fuels, oils, fats, unstable chemicals, acids, disinfectants, or general organic liquids. Moreover, any kind of rubber and some materials or mixtures in contact with the damage will occur, including manganese, iron, copper and its alloys. The rubber tube should be protected from contact with polyvinyl chloride (PVC) or wood or cloth impregnated with excess oil.